stitch and glue

Another Sassafras Penobscot Replica Part 1

ManX's recent paddle submission based on the c.1900 Antique Penobscot Paddle inspired me to finally get around and work on a similar paddle paddle blank that had been lying around.

Back when I did my own replica based on this elegant looking paddle design, the original lumber stock had been a thick piece of 8/4 Sassafras stock. At the time, I didn't think ahead and rip the original lumber down to 5/4 but rather cut the pattern out on the bandsaw directly. This of course left a comically thick paddle blank that would be extremely laborious to shave down with hand tools. It was then that I decided to rip the paddle blank roughly in half and basically end up with two twin blanks. In the whole process though the blanks ended up poorly cut, but salvageable. The better of the two blanks ended up being the replica while its twin languished around for a few a years.



Original Paddle; My Replica


As usual with sassafras, the wood is easy to carve with both a spokeshave and crooked knife. I ended up using both tools to thin the blade and shape the grip while trying to correct some of the errors from the initial sawing out of the blank.


As you might've noticed, this blank had one major flaw and that was a knothole that was on the upper part of the blade. Fortunately, it only projects onto one face. Here's a closeup shot of the area while the paddle was still in its rough carving phase.

Time will only tell if this will lead to a catastrophic break, but the grain pattern does reverse and get more challenging to carve with the spokeshave and crooked knife around this area. However, I remember a historic paddle photo of some Maliseet guides posing with their paddles. The man on the right has a paddle that clearly has a knothole in the upper section as well so this "defect" may not be in too critical a location.